Cleaning The Storage Container - Wessamat HighLine W25 LE Mode D'emploi

User manual - English

7.2.2 Cleaning the storage container:

(Also see service video capitel 10. or QR code)
If chapter 7.2.1 has already been carried
out, continue with point 3.
1. Start up the ice cube maker by
switching on the production switch
(Position "Produktion ein/on").
2. Switch off the machine at the
production switch (Position "Produktion
aus/off").
3. Remove any ice remaining in the
storage container. Ice intended for
consumption must not come into contact
with the detergent!
4. Remove the metal plate inserts for
draining the condensation water from the
storage container.
5. Thoroughly spray
container and the metal plate inserts with
WESSAMAT special cleaner and allow a few minutes for the cleaner to act.
6. Rinse the storage container and the metal plate inserts with clear water in order to remove
the special cleaner and dissolved deposits. Neutralise the remaining special cleaner residues
with soap water. A sponge or cloth may be used for this purpose.
7. Plug in the socket
8. Place the metal plate inserts into the storage container.
IMPORTANT:
Almost all cleaners contain acids which can cause corrosion. Therefore, all stainless
steel parts that have been treated with cleaner must be rinsed thoroughly.
!
CAUTION
The first two to three ice drops should be removed from the storage container after
cleaning. There is a risk that this ice may contain residues of cleaning agents and
therefore it is not suitable for consumption.
User-manual-HighLine-v.02
the storage
Abb. 7.2.2: Darstellung Vorratsbehälter und Verflüssiger
Verflüssiger
Vorrats-
behälter
Einlege-
blech
Frontblende
unten
01/2021 55