Wessamat HighLine W25 LE Mode D'emploi page 50

User manual - English
2. Release the left locking screw at the ice thickness limit switch.
3. Change the position of the ice thickness limit switch:
Move upwards → thicker cubes
+
Move downwards → thinner cubes
-
4. Tighten the screw, insert the power plug
and switch on
"Produktion ein/on") and monitor a production
cycle.
5. Once the required ice thickness is
reached, switch off the machine (Position
"Produktion aus/off") and pull the power plug.
Replace the electrics box and housing covers
and fasten the screws. Re-start the machine.
IMPORTANT:
At the maximum setting, ensure that a minimum distance of approx. 1.5 to 2 mm
remains between the individual finished ice cubes (see Fig. 6.3). Otherwise there is a
risk of the machine producing an ice plate, which would lead to malfunction.
User-manual-HighLine-v.02
Limit switch ice thickness
Positioning Bolt for ice
thickness
the machine (Position
Fixing bolt
Minimum distance 1.5 – 2 mm
Fig. 6.3: Setting the ice cube thickness
01/2021 50