Handling And Use; Filling With Water - SilverCrest SDB 1500 B2 Mode D'emploi

Handling and use

This section provides you with important information on handling and using the
appliance.

Filling with water

CAUTION – PROPERTY DAMAGE!
► Never operate the appliance without water in the water tank
could overheat and be damaged!
1) Push the "Water tank" release button
the water tank
2) Turn the water tank
3) Fill the water tank
NOTE
If the mains water in your location is rated as hard, we recommend
that you mix the mains water with some distilled water. Otherwise, the
jets for the steam blast function could become blocked with limescale
prematurely.
To extend the optimal steam blast function, mix mains water with
distilled water according to the table:
Water hardness
Ask your local water utility about the water hardness in your area.
4) Screw on the camp hand-tight.
5) Turn the water tank
First, insert the lower part into the main unit
into the appliance. Push it firmly into place so that the water tank
clicks into place and sits firmly onto the main unit
GB │ IE
■ 30
│
off the appliance with a tilting motion towards the rear.
over and unscrew the cap.
with tap water up to the MAX mark.
Ratio of distilled
very soft/soft
medium
hard
very hard
back around and place it back onto the main unit
downwards. At the same time, pull
water to tap
water
0
1:1
2:1
3:1
and then flip the top part
! The pump
audibly
.
SDB 1500 B2
: