Replacing The Filter - SilverCrest SDB 1500 B2 Mode D'emploi

Reinsert the rotary brush "B":
Fig. 2
6) Push the side of the rotary brush "B" with the recess "C" onto the drive shaft
"D" (see Fig. 2).
7) Push the other end of the rotary brush "B" into the housing so that the rotary
brush "B" sits straight in the housing again.
8) Reinsert locking device "A" and let it click into place.
Replacing the filter
After 4–6 months, or approximately 100 cleaning cycles (one cycle corresponds
to one water tank filling), you will need to change the filter
our Service Department for replacement filters.
RISK OF ELECTRICAL SHOCK!
► Before changing the filter
To remove the filter
9) Pull the filter
10) Insert the new filter
11) Replace the water tank
SDB 1500 B2
, always pull out the mains plug!
, first remove the water tank
upwards out of the appliance.
.
.
C D
. Please contact
from the appliance.
GB │ IE
35
│
■