Changing Saw Blade; Gearbox; Cleaning; Disposal - HOLZMANN MASCHINEN BS 210TOP Mode D'emploi

14.2

Changing saw blade

Remove the saw blade protection cover by loosening and removing all screws.

Loosen the saw band with the hand wheel entirely.

Now remove cautiously the old saw band. Use cutting proof gloves.

Install the new saw blade. Insert it first through both saw blade guide bearings and then lay

them onto the flywheels.
ATTENTION: Take care to install the saw band correctly! Check the direction of the teething.

Tension the saw band with hand wheel.

You can check the tension by applying in the middle of the free blade section a pressure of

approx. 50Nm on the blade side. The blade is tensioned correctly, if it can be moved 3mm
sidewards out of the straight cutting line.
Turn by hand a flywheel and check the saw band for straight run

14.3

Gearbox

The gear box should not need changing unless the oil
becomes contaminated or leaks.
To check the oil, raise the saw arm to vertical position.
Wait a few minutes for the oil to drain down.
Loosen the vent screw (R) on top of the gearbox. The gear
case is full when the oil is up to the bottom of the filler
hole.
Use gear oil ISO 220 if it becomes necessary to change or
add to the oil.
14.4

Cleaning

After each workshift the machine has to be cleaned. Remove chips etc. with a suitable tool. Do
not remove them by hand (cutting injury!). Remove dust as well.
The usage of certain solutions containing ingredients damaging metal surfaces
as well as the use of scrubbing agents will damage the machine surface!
Clean the machine surface with a wet cloth soaked in a mild solution
14.5

Disposal

Do not dispose the machine in residual waste. Contact your local authorities for
information regarding the available disposal options. When you buy at your local
dealer for a replacement unit, the latter is obliged to exchange your old.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
NOTICE
MAINTENANCE
31
BS 210TOP / BS 275TOP