Operation; Control Panel; Adjusting; Blade Tension - HOLZMANN MASCHINEN BS 210TOP Mode D'emploi

13.2

Operation

13.2.1 Control panel

SB1 ON-switch
SB2 OFF-switch
SB3 EMERGENCY switch
13.3

Adjusting

13.3.1 Blade tension

The ideal tension of the blade is achieved rotating the hand wheel until it
touches the micro switch, that actuates the operation of the machine is
actuated.
Proper blade tension is 4 to 8 MPa as measured on a blade tension gauge.

13.3.2 Blade guide

 Loosen the ratchet screw (J)
 Hold the handle(K) and slide blade guide block as close as
possible to the material without interfering with cut.
 Tighten the hex socket screw(J)
The blade guide is pre- set for a blade with 0,9 mm thickness
Loosen Allen screw (L), adjusting the set
screw (M), the movable teeth (Q) will far
away or close to the blade.
Make sure that between blade and two side
teeth there is at least 0.1mm of play.
Then re-tighten Allen screw (L).
Make sure that between blade and upper
teeth of the pad this is at least 0.2~0.3 mm
of play; if necessary, loosen the Allen screws
(P) that fasten the block and adjust
accordingly.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
SA1 2-step-switch
SA2 Coolant switch
OPERATION
28
BS 210TOP / BS 275TOP