Operation; Operation Instructions - HOLZMANN MASCHINEN BS 210TOP Mode D'emploi

13

OPERATION

Device to be operated in a perfect state only. Inspect the device visually every time it is to be
used. Check in particular the safety equipment, electrical controls, electric cables and screwed
connection for damage and if tightened properly. Replace any damaged parts before operating
the device.
13.1

Operation instructions

Perform all machine settings with the machine being
Checks to carry out before each workshift:









Checks to carry out before each cut:









HOLZMANN MASCHINEN GmbH
WARNING
disconnected from the power supply!
General technical condition of the machine
Safety equipment available and in working order
Check sawband for wear and replace if necessary
Check the coolant level and top up if necessary
Moving parts are not blocked
All the components for correct fit and function, especially the screws
on the blade guard and lever control!
All the tools for service / maintenance from the machine.
Set the blade guard as close as possible to the workpiece.
Splash guard
Angle set correctly?
Vice adequately fixed?
Make sure that the material to be processed is fixed properly in the
vice.
Ensure that the coolant circulates properly.
Running direction of saw blade.
Never switch the machine on while pressing the blade against
the material!
Wait until the sawband has reached full speed – then
performing the cut!
For the cooling of the blade fill the tank with coolant liquid
(KSM5L)
Always support long overhanging workpieces additionally
www.holzmann-maschinen.at
NOTICE
OPERATION
27
BS 210TOP / BS 275TOP