14
OPERATION
14.1
Operating notes
Perform all machine settings with the machine being
TAKE ATTENTION when cutting long workpieces without
additional support!
Hazard of machine damage and injuries through upbouncing
workpiece.
Therefore: always support long overhanging workpieces additionally
Let the engine run full speed when you begin to cut a work a
workpiece
14.2
Settings
14.2.1 Swivel table
Loosen the lock with the quick-release lever.
Swing the table to the angle adjustment knob
to the desired angle.
Fix the table with the table locking handle in
front of the first section
The desired angle is expediently to be
checked by test cuts
14.2.2 Aligning the saw band / tilt adjustment
If the bandsaw blade is not running in the center on the rollers, is corrected by adjusting the
inclination of the caster the position of the saw blade.
Open the upper and lower rollers cover (Fig. A)
Turn by hand slowly in the upper roller clockwise. The saw blade to run centered on the
rubber pads of the caster. If this is not the case, the inclination angle of the upper
Sägebandrolle must be corrected.
Loosen the lock (Fig.B) using the rotary knob.
Turn to control the roller by hand in a clockwise direction around the barrel of the saw band.
Note that the running direction of the saw blade from top to bottom. Correct the running of
the saw blade by turning the knob left or right.
Now check the running of the saw band on the lower roller. It should lie in its entire width on
the rubber pad. Correct the run until the saw band on the upper Sägebandrolle running
centered.
After the adjustments fix again everything and close both covers
HOLZMANN MASCHINEN GmbH
W A R N I N G
disconnected from the power supply!
www.holzmann-maschinen.at
A T T E N T I O N
N O T I C E
Angle adjustment knob
OPERATION
Table locking handle
37
HBS 230HQ