Lower blade guide (Fig.l)
The lower blade guide must be readjusted after each band saw blade change or tracking
adjustment.
Through the hole (B) and (E), use hex
wrench to loosen socket bolts, adjust
guide block (D) and thrust bearing
(C) just like adjusting upper blade
guide.
Loosen the screw (A), and adjust the
guide bearing to a position 0.5mm
away from blade. Retighten the screw
(A).
14.3
Operation
14.3.1 Start / Stop
To turn ON or OFF the machine, press the main switch
To use LED-light, turn ON the light switch.
14.3.2 Miter gauge
To use the miter gauge fence, slide it into the slot
provided.
To adjust the angle of the miter cut, loosen lock,
move the miter gauge to the desired position (60 °)
and fix him afterwards.
HOLZMANN MASCHINEN GmbH
www.holzmann-maschinen.at
LED light switch
Main switch
Lock knob
OPERATION
Miter gauge
40
HBS 230HQ