Assembly Instructions - Franke AQUA629 Notice De Montage Et De Mise En Service

10. Assembly Instructions

10.1 Connect to the water supply.
☞
Check the direction of flow.
10.2 Align the water volume regulator in such a way, that operating elements are facing
forwards.
10.3 Open the flow volume regulator.
a: closed
b: open
10.4 Flush the pipes in compliance with DIN 1988.
10.5 Close the flow volume regulator.
10.6 Open the locking screw of the flow volume regulator.
10.7 Insert the grit filters.
☞
Important!
Observe the installation direction of the grit filter.
10.8 Screw in the screw plug.
10.9 Remove the flush connector.
10.10 Insert the solenoid valve with the seals.
☞
Check the direction of flow.
10.11 Install a switch box (not included in scope of delivery ) at a height of
approx. 1200 mm.
10.12 Install a conduit (not included in scope of delivery; Ø
switch box.
☞
To protect the tiles, use masking tape when marking and drilling.
10.13 Hold the cover plate with Piezo-button at a height (c) of approx. 1200 mm against
the wall.
10.14 Mark the drill holes.
☞
To protect the tiles, drill at a low speed.
10.15 Drill according to the markings.
10.16 Insert the dowels.
☞
Depending on the composition of the wall, special wall dowels may have to be used
(not included in scope of delivery).
10.17 Pull the extension line for the sensor line through the conduit.
10.18 Connect together the sensor line of the Piezo-button and the extension line.
10.19 Screw on the cover plate.
inside
- 6 -
= min. 20 mm) to the