iwc GST Aquatimer Mode D'emploi page 16

Attaching the bracelet
Attach the component parts of the
bracelet link to the connection
point, and push the pivot pin into
the bracelet from the side (1).
Using the special tool provided,
now press the securing pin down-
wards (2) and, at the same time,
slide the pivot pin back into
the bracelet until it lies flush (3).
The securing pin must be brought
up flush with the upper edge of the securing link. Please
be sure to check the correct seating of the pivot pin.
Removing and fitting the nylon Velcro strap
We can supply a specially developed, tear-resistant
nylon Velcro strap as a special accessory. This is suit-
able, when used in combination with the metal bracelet,
for all conceivable wrist diameters. It is designed so that
it can be tightened or loosened at any time, including
under arduous conditions. This allows simple and easy
adjustment to the variation in the circumference of the
wrist when diving in a suit. When fitting the Velcro strap,
care must be taken to ensure that the pivot pin is
securely seated to exclude the possibility of losing the
watch.
Status October 1997.
Technical specifications subject to change.
28 | 29