Specifications; Unpacking - CASTLE Serenity Instructions D'utilisation

SPECIFICATIONS

Model Number
BTU/hour input (1)
Heating Capacity (2)
Electrical Rating (3)
Power Consumption
Fuel Storage Capacity
Flue Size (4)
Width
Height
Depth
Weight
(1) Heat output will vary, depending on the brand, type and
quality of fuel and the moisture content. Consult your
dealer for best results.
(2) Based on post 1982 home construction, requiring 35
BTU/Hr. per Sq. Ft.
(3) Install per NFPA 70 and follow all state and local codes,
contact licensed electrical contractor for assistance.
(4) Install per NFPA 211 and follow all state and local codes,
contact licensed installers for assistance.
Listing label:
Tested to the following standards: UL1482, ASTM E1509, ULC/
ORD-C1482-M1990, UCL S627-2000, and E2779
Glass Specifications:
This stove is equipped with 5 mm ceramic glass. Replace glass
only with Castle Pellet Stoves ceramic glass. Call your servicing
dealer or Castle at 1-800-345-6007 for replacement parts.
Check for parts online at www.castlestoves.com or call 800-450-EDGE (3343) M-F 8-5
Serenity
4.0 lbs/hr
1,500 sq. ft.
115 Volts, 60 Hz
402 Watts ignition
77 Watts operating
40 lb
3 in.
18.25 in.
34 in.
23.75 in.
186 lb
Operator's Manual
Serenity Pellet Stove
CAUTION
THIS INSTALLATION MUST CONFORM WITH
LOCAL CODES. IN THE ABSENCE OF LOCAL CODES
YOU MUST COMPLY WITH ASTM E1509, (UM) 84-
HUD, ULC/ORD-C-1482 AND AND UCL S627-2000.
CASTLE PELLET STOVES, MANUFACTURER OF
THIS APPLIANCE, RESERVES THE RIGHT TO ALTER
ITS PRODUCTS AND/OR THEIR SPECIFICATIONS
WITHOUT NOTICE.
MAKE SURE THE HOPPER IS FREE OF ALL FOREIGN
MATTER BEFORE FILLING WITH FUEL. FOREIGN
MATERIAL WILL CAUSE AUGER JAMS AND WILL
VOID STOVE WARRANTY.

UNPACKING

Your Castle Serenity will come fully assembled. Remove all
packing material and tape from the inside of the firebox. Remove
any tape on the outside of the glass. Open the hopper, remove all
packing material and power cord.
9