CASTLE Serenity Instructions D'utilisation page 27

Setting The Temperature Units
1. Press and hold the ENTER button. This will take you to
the "SET DATA" screen.
2. Using the SCROLL DOWN key, move down to option
3: "SET TEMPERATURE UNITS". Press ENTER again to
move into the "SET TEMPERATURE UNITS" screen. SEE
FIGURE 25.
3. In the set temperature units menu, press the ENTER
button to highlight the units. Use the SCROLL UP and
SCROLL DOWN buttons to choose either Celsius (C°) or
Fahrenheit (F°).
4. When finished, press ENTER. With nothing highlighted
on the screen, press the EXIT button.
Set Temperature Units
Temperature Units: C°
Figure 25
Setting The Blower Voltage
The blower voltage (controlling the room fan) can be turned up
or down for each power level to regulate the amount of heat
circulated into a room during stove operation. Some fuels radiate
heat better than others. You have the ability to speed up or
slow down the room fan to extract the optimum amount of heat
without blowing cold air.
Increasing the blower voltage causes the convection motor to run
faster, extracting more heat from the unit.
NOTE: If having issues with the stove overtemping in any
setting, increase the blower voltage.
Decreasing the blower voltage allows you to slow the exchange of
heat from the stove so it blows less cold air.
Check for parts online at www.castlestoves.com or call 800-450-EDGE (3343) M-F 8-5
Operator's Manual
Serenity Pellet Stove
To Set The Blower Voltage:
1. Press and hold the ENTER button. This will take you to
the "SET DATA" screen.
2. Using the SCROLL DOWN key, move down to option 4:
"SET BLOWER VOLTAGE". Press ENTER again to move
into the "SET BLOWER VOLTAGE" screen. SEE FIGURE
26.
3. Select the stall (or heating power level) for the
voltage you'd like to change by scrolling up or down
and pressing ENTER. The voltage amount will
automatically be highlighted.
4. Using the SCROLL UP or SCROLL DOWN keys, select
the appropriate voltage.
NOTE: Voltage can be decreased or increased only in
increments of five (5).
5. Press ENTER to finalize your changes. Repeat steps 2-4
for the other stalls if you so desire.
Set Blower Voltage
1.Stall1 Voltage:~85V
2.Stall2 Voltage:~90V
3.Stall3 Voltage:~95V
4.Stall4 Voltage:~100V
5.Stall5 Voltage:~110V
Figure 26
27