CASTLE Serenity Instructions D'utilisation page 5

CAUTION
ALL APPLICABLE BUILDING CODES FOR YOUR
LOCATION MUST BE FOLLOWED. IN AREAS
WHERE BUILDING CODES REQUIRE ADDITIONAL
STEPS TO THE INSTALLATION OF THIS PRODUCT
NOT INCLUDED IN THIS MANUAL, THE BUILDING
CODES WILL TAKE PRECEDENT AND MUST BE
FOLLOWED. CONTACT YOUR LOCAL BUILDING
INSPECTOR TO OBTAIN ANY NECESSARY PERMITS
OR INSPECTION GUIDELINES BEFORE INSTALLING
THE PRODUCT.
CONTACT LOCAL BUILDING OR FIRE OFFICIALS
ABOUT RESTRICTIONS
INSPECTION REQUIREMENTS IN YOUR AREA.
CONTACT YOUR LOCAL AUTHORITY (SUCH
AS MUNICIPAL BUILDING DEPARTMENT, FIRE
DEPARTMENT, FIRE PREVENTION BUREAU, ETC.)
TO DETERMINE THE NEED FOR A PERMIT.
THE CASTLE PELLET STOVES PELLET STOVE IS
DESIGNED TO BURN PELLET FUEL ONLY.
A WORKING SMOKE DETECTOR IS REQUIRED AND
MUST BE INSTALLED IN THE SAME ROOM AS THE
STOVE.
THIS STOVE IS NOT INTENDED FOR USE IN
COMMERCIAL APPLICATIONS.
DOOR AND ASH PAN MUST BE CLOSED AND
LATCHED DURING OPERATION.
NOTIFY YOUR INSURANCE COMPANY OF PELLET
STOVE INSTALLATION.
THIS INSTALLATION MUST CONFORM WITH
LOCAL CODES. IN THE ABSENCE OF LOCAL CODES
YOU MUST COMPLY WITH ASTM E1509, (UM) 84-
HUD, ULC/ORDC-1482, AND UCL S627-2000.
THE STRUCTURAL
MANUFACTURED HOME FLOOR, WALL, AND
CEILING/ROOF MUST BE MAINTAINED.
KEEP COMBUSTIBLE MATERIALS (SUCH AS
GRASS, LEAVES, ETC.) AT LEAST THREE FEET AWAY
FROM THE FLUE OUTLET ON THE OUTSIDE OF THE
BUILDING.
THIS STOVE SHOULD NOT BE USED AS THE
ONLY SOURCE OF HEAT IN THE HOUSE. POWER
OUTAGES AND PERIODIC MAINTENANCE WILL
RESULT IN A TOTAL LOSS OF HEAT.
DO NOT LEAVE HOPPER DOOR OPEN.
Check for parts online at www.castlestoves.com or call 800-450-EDGE (3343) M-F 8-5
AND INSTALLATION
INTEGRITY OF THE
Operator's Manual
Serenity Pellet Stove
CAUTION
INSTALLATION AND REPAIR OF THIS PELLET
STOVE SHOULD BE DONE BY A QUALIFIED SERVICE
PERSON. THE APPLIANCE SHOULD BE INSPECTED
BEFORE USE AND AT LEAST ONCE A YEAR BY A
QUALIFIED SERVICE PERSON. IT IS IMPERATIVE
THAT THE CONTROL COMPARTMENTS, FIRE BOX,
AND THE CIRCULATING AIR PASSAGEWAYS OF THE
STOVE BE KEPT CLEAN.
THE OPERATION OF EXHAUST FANS SUCH AS
BATHROOM FANS, ATTIC FANS, ETC. MIGHT
STARVE THE PELLET STOVE OF COMBUSTIBLE AIR
CREATING A NEGATIVE PRESSURE IN THE ROOM.
PROVIDE ADEQUATE VENTILATION OF THE ROOM
ACCOMPANYING THE PELLET STOVE. IF NOT, THE
PRESSURE SWITCH MAY SHUT OFF OPERATION OF
THE PELLET STOVE.
THE MOVING PARTS OF THIS STOVE ARE PROPELLED
BY HIGH TORQUE ELECTRIC MOTORS. THESE PARTS
CAN CAUSE SEVERE DAMAGE TO BODY PARTS
THAT GET NEAR THEM. KEEP ALL BODY PARTS
AWAY FROM AUGER AND FANS WHILE THE STOVE
IS PLUGGED INTO AN ELECTRICAL OUTLET. THESE
MOVING PARTS MAY BEGIN TO MOVE AT ANY TIME
THE STOVE IS PLUGGED IN.
THE VENT SURFACES CAN GET HOT ENOUGH TO
CAUSE BURNS IF TOUCHED. NONCOMBUSTIBLE
SHIELDING OR GUARDS MAY BE REQUIRED.
INSTALL VENT AT CLEARANCES SPECIFIED BY THE
VENT MANUFACTURER.
ALL VENTING JOINTS, WHETHER VERTICAL OR
HORIZONTAL, SHOULD BE MADE GAS-TIGHT
WITH RECOMMENDED SEALANTS SPECIFIED BY
VENT MANUFACTURER.
ACCORDING TO HUD (HOUSING & URBAN
DEVELOPMENT) REQUIREMENTS,
INSTALLED IN A MOBILE HOME, THIS STOVE MUST
BE GROUNDED DIRECTLY TO THE STEEL CHASSIS
OF THE MOBILE HOME AND BOLTED TO THE
FLOOR. DIRECT AIR ACCESS MUST BE PROVIDED,
USE A FRESH AIR KIT.
FOR USE IN THE UNITED STATES AND CANADA.
APPROVED FOR INSTALLATION IN MOBILE
HOMES.
CASTLE PELLET STOVES, PRODUCER OF THIS
APPLIANCE, RESERVES THE RIGHT TO ALTER ITS
PRODUCTS, SPECIFICATIONS AND/OR PRICE
WITHOUT NOTICE.
WHEN
5