Monthly Maintenance - CASTLE Serenity Instructions D'utilisation

In addition to daily maintenance tasks, use an ash vacuum to
clean the inside of the firebox.
Remove the firepot from the pot holder and vacuum beneath.
Be sure to remove any ash from the incoming ignitor tube. SEE
FIGURE 34.

Monthly Maintenance

The exhaust venting system should be inspected at least once per
month to determine if cleaning is necessary.
Annually/ Biannually
Remove and clean the exhaust venting.
Remove and clean the combustion motor, housing and impellers.
To remove the combustion motor, you will have to remove the
side panel on the stove. To remove the panel:
Remove four screws, two at the top and two at the bottom of the
panel. SEE FIGURE 35.
Pivot rear panel outward and push front of panel inward to
release and remove panel.
Once you've removed the side panel, you can remove and clean
the combustion motor, housing and impellers. SEE FIGURE 36.
32
Figure 34: Remove ash from ignitor tube (underneath firepot)
Figure 35: Remove (2) screws from rear of side panel, at the top and
Figure 36: Remove combustion motor and clean
Check for parts online at www.castlestoves.com or call 800-450-EDGE (3343) M-F 8-5
Operator's Manual
Serenity Pellet Stove
bottom of the panel. Remove (2) screws from the front face
of the side panel, at the top and bottom of the panel.