Pre-Operation; Mounting Your Controller; Prior To Starting - CASTLE Serenity Instructions D'utilisation

PRE-OPERATION

Once the stove has been properly installed and plugged into a
grounded surge protector you are ready to begin operation.

Mounting Your Controller

Mount the controller and the controller bracket to top and back of
your stove using the hardware that accompanied the controller.
SEE FIGURE 18.

Prior To Starting

Turn on the main power switch located on the back of the stove.
SEE FIGURE 20A.
NOTE: If for some reason the stove does not appear to be
powering on, there is a fuse located just below the
power switch that can be checked. SEE FIGURE 20B.
There is a spare fuse located in the fuse holder.
Make sure the hopper is clean and free of foreign matter including
pellet fines and dust.
Fill the hopper with wood pellets, making sure that NO parts of
the bag or any foreign objects enter the hopper as this may cause
harm to the auger feed system. SEE FIGURE 21.
Also take care in making sure there is no pellet material in the
hopper lid seating surfaces.
Close the lid. This stove has a safety switch that will not allow
pellets to feed with the hopper door open.
Make sure the main glass door is closed. The stove has a safety
switch that will not allow the stove to feed fuel unless there is
negative draft pressure inside the stove.
Before starting your Castle Stove, you will need to determine in
which mode you would like to run the stove. The Serenity can
operate in three modes:
1. Manual: Under this mode, you can personally adjust
and set the heating phase to control the heat level.
2. Thermostat Control (Temperature): Under his mode,
you can set the room temperature and the stove
will automatically run to ensure the room is at that
temperature.
3. Weekly: Under this mode, the stove will work
automatically during days and times you designate. You
can have a program for each of the seven days of the
week and four periods during the day.
You must select your mode before turning on the stove.
Selecting a mode while the stove is burning can cause the stove
to shut down and may force a 30-minute delay in restarting.
You do not need to start operation of the stove to select your
mode. To choose the mode, select the mode transfer button
Pressing the mode button once selects the thermostat setting;
selecting it twice will bring you to the weekly mode.
24
NEVER USE FLAMMABLE LIQUIDS SUCH AS
GASOLINE, GASOLINE TYPE LIGHTER FUEL,
CHARCOAL LIGHTER FUEL OR FIRE STARTING
GELS IN OR AROUND THIS STOVE. KEEP ALL
SUCH LIQUIDS WELL AWAY FROM THE STOVE
WHEN IT IS IN USE.
NEVER OPEN SIDE PANELS OR MAIN DOOR
WHEN STOVE IS IN OPERATION.
NEVER TOUCH DOOR LATCHES WHILE IN
OPERATION, THEY GET EXTREMELY HOT. NEVER
OPEN GLASS DOOR WHILE STOVE IS OPERATING
OR WHILE STOVE IS HOT.
Figure 20a: Main power switch
Figure 20b: Main power switch
.
Figure 21: Pellet load
Check for parts online at www.castlestoves.com or call 800-450-EDGE (3343) M-F 8-5
Operator's Manual
Serenity Pellet Stove
WARNING