Pre-Operation - CASTLE Serenity Manuel De L'utilisateur

PRE-OPERATION

Once the stove has been properly installed and plugged into
a grounded surge protector you are ready to begin operation.
MOUNTING YOUR CONTROLLER
Mount the controller and the controller bracket to top and back of
your stove using the hardware that accompanied the controller.
SEE FIGURE 18 ON PAGE 22.
PRIOR TO STARTING
Turn on the main power switch located on the back of the stove.
SEE FIGURE 20A.
NOTE: IF FOR SOME REASON THE STOVE DOES NOT APPEAR TO
BE POWERING ON, THERE IS A FUSE LOCATED JUST BELOW THE
POWER SWITCH THAT CAN BE CHECKED. SEE FIGURE 20B. NOTE
THAT THERE IS A SPARE FUSE LOCATED IN THE FUSE HOLDER.
Make sure the hopper is clean and free of foreign matter including
pellet fines and dust.
Fill the hopper with wood pellets, making sure that NO parts of the
bag or any foreign objects enter the hopper as this may cause harm
to the auger feed system. SEE FIGURE 21.
Also take care in making sure there is no pellet material in the hopper
lid seating surfaces.
Close the lid. This stove has a safety switch that will not allow pellets
to feed with the hopper door open.
Make sure the main glass door is closed. The stove has a safety switch
that will not allow the stove to feed fuel unless there is negative draft
pressure inside the stove.
Before starting your Castle Stove, you will need to determine in which
mode you would like to run the stove. The Serenity can operate in
three modes:
1. Manual: Under this mode, you can personally adjust and set
the heating phase to control the heat level.
2. Thermostat Control (Temperature): Under his mode, you can set
the room temperature and the stove will automatically run to
ensure the room is at that temperature.
3. Weekly: Under this mode, the stove will work automatically
during days and times you designate. You can have a program
for each of the seven days of the week and four periods during
the day.
You must select your mode before turning on the stove. Selecting
a mode while the stove is burning can cause the stove to shut down
and may force a 30-minute delay in restarting.
You do not need to start operation of the stove to select your mode.
To choose the mode, select the mode transfer button . Pressing
the mode button once selects the thermostat setting; selecting it
twice will bring you to the weekly mode.
24
All manuals and user guides at all-guides.com
Figure 20a: Main power switch
Figure 20b: Main power switch
Figure 21: Pellet load
Check for parts online at www.castlestoves.com or call 800-345-6007 M-F 8-5 CST
WARNING
NEVER USE FLAMMABLE LIQUIDS SUCH AS GASOLINE,
GASOLINE TYPE LIGHTER FUEL, CHARCOAL LIGHTER
FUEL OR FIRE STARTING GELS IN OR AROUND THIS
STOVE. KEEP ALL SUCH LIQUIDS WELL AWAY FROM
THE STOVE WHEN IT IS IN USE.
NEVER OPEN SIDE PANELS OR MAIN DOOR WHEN
STOVE IS IN OPERATION.
NEVER TOUCH DOOR LATCHES WHILE IN OPERATION,
THEY GET EXTREMELY HOT.
NEVER OPEN GLASS DOOR WHILE STOVE IS OPERATING
OR WHILE STOVE IS HOT.
Operator's Manual
Serenity Pellet Stove