CASTLE Serenity Manuel De L'utilisateur page 35

PROBLEM
Fuel not feeding, no hopper lid
signal on control
PROBLEM
Fire burns lazy and smoky
PROBLEM
Feeds fuel will not light all;
control indicators are on
Check for parts online at www.castlestoves.com or call 800-345-6007 M-F 8-5 CST
All manuals and user guides at all-guides.com
CAUSE
Hopper lid is open
Hopper lid switch not function-
ing correctly
CAUSE
Stove is dirty
Poor quality fuel
CAUSE
Igniter tube or burn pot plugged
with ash
Faulty igniter
SOLUTION
Close hopper door. Enter the diagnostic area on the con-
troller; circle next to "limit" should be highlighted when
the hopper lid is closed. The circle will be unshaded if
the hopper lid is opened.
Check hopper door seal.
Replace hopper safety switch if not operating properly.
SOLUTION
Clean fire pot.
Clean ash pan.
Clean exhaust vent system.
Clean stove through cover plate clean-out hole.
Increase exhaust motor voltage.
SOLUTION
Clean fire pot, clean igniter tube. Enter the diagnostic
area in the controller and test the ignitor by highlight-
ing "fire". You should feel heat coming from the igniter
holder within two minutes.
Replace if necessary
Operator's Manual
Serenity Pellet Stove
35