Transportation And Storage - Ryobi EMS254L Traduction Des Instructions Originales

by using a carpenter's set or mitre square.
WARNING
The manufacturer strongly recommends that the
product is always securely mounted to a bench top or
its dedicated stand.
top or the dedicated stand by the four nuts, bolts and
bevel and mitre setting without the possibility of it tipping
over. If the product is not secured properly, the product may
over balance when large bevel angles are selected.
help prevent the mitre saw from over balancing.
There is also an adjustable screw (balancing foot) that
that the product is resting upon. This will also prevent the
of the slide and bevel. Beware, this part of the saw table
moves when different mitre angles are selected, so the
screw needs to be frequently adjusted and reset.
MAINTENANCE
Do not modify the product in any way or use accessories
not approved by the manufacturer. Your safety and that
of others may be compromised.
Do not use the product if any switches, guards or
other functions does not work as intended. Return to
an authorised service centre for professional repair or
adjustment.
Do not make any adjustments whilst the saw blade is
in motion.
Always make sure the power plug has been
removed from the mains power source before
making adjustments, lubricating or when doing any
maintenance on the product.
Before and after each use, check the product for
damage or broken parts. Keep the product in top
working condition by immediately replacing parts with
spares approved by the manufacturer.
The blade is very hot after use, wear gloves or allow to
cool before maintenance or cleaning procedures.
Clean out accumulated dust using a brush or vacuum
cleaner. Do not use compressed air.
To assure safety and reliability, all repairs, including
changing brushes, should be performed by an
authorised service centre.
If the power supply cord is damaged, it must be
replaced only by the manufacturer or by an authorized
service centre to prevent damage to the saw or risk of
electrocution.
WARNING
For greater safety and reliability, all repairs should be
performed by an Authorised Ryobi Service Centre.
Maximum cutting depth stop
blade from cutting into the metal base of the unit.
WARNING

TRANSPORTATION AND STORAGE

When storing the product, disconnect the power
cord. Store the product in a secure place that is not
accessible to children. Store the power cord as shown
in the illustration on page 196 - 199 of this manual.
Clean the product using a brush and vacuum cleaner
before storage.
If you remove the saw blade or keep spares with
the unit, ensure they are in the original packaging to
prevent injury.
To secure the product prior to movement:
The product should be stored at the zero degree mitre
and bevel angle and locked in position. The slide should
be locked. The handle should be locked in the lower
(safe) position with the guards closed.
One or both sides of the work piece supports can be
removed for ease of carrying.
legs:
Secure the product prior to movement as described in
the manual.
two operators wearing heavy duty gloves. One operator
should stand at the front while the second operator is
at the back of the saw stand. Both operators must hold
the top of each leg and carefully lift the whole assembly.
To move longer distance or in a vehicle:
Secure the product prior to movement as described in
the manual.
The stand must be removed by releasing the 4 bolts,
one at each corner. Secure the bolts for future use. Lift
the product using the handle at the top.
When lifting to a height, two persons wearing heavy
gloves are needed to lift the base of the product.
When transporting in a vehicle, set the product on its
base and secure against movement.
Lay the stand on its side or dismantle and secure
EN
English
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
EL
TR
UK
5