Transportation And Storage - Ryobi R18MS216 Traduction Des Instructions Originales

The product may move and tip if it is not adequately
secured.
Set up and lock the cutting angles and depth before
making the cut.
Secure the workpiece to the mitre saw base. Use the
clamp provided and, where necessary, use additional
clamps or holding mechanisms to prevent unintentional
movement of the workpiece while cutting.
Check that the operation of the blade guards are not
restricted by the position of the workpiece.
Ensure that the fence and other parts of the product
will not be cut as the blade lowers to the cutting
position.
Start the motor and allow the blade to reach full speed
before slowly lowering it to cut the workpiece. Slide
the blade assembly backwards to complete the cut as
necessary.
Allow the blade assembly to rise to its upper position
where the blade guards are fully closed. Switch off the
motor and allow the blade to come to a complete stop
before removing the workpiece or off-cuts, or before
reaching into the area of the blade.
set on the product matches the angle to be produced on
the workpiece. Check this on a discarded piece of wood by
using a carpenter's set or mitre square.
WARNING
The manufacturer strongly recommends that the product
is always securely mounted to a bench top.
top by four nuts, bolts and washers as instructed, the
without the possibility of it tipping over. If the product is not
secured properly, the product may over balance when large
bevel angles are selected.
help prevent the mitre saw from over balancing.
There is also an adjustable screw (balancing foot) that
that the product is resting upon. This will also prevent the
of the slide and bevel. Beware, this part of the saw table
moves when different mitre angles are selected, so the
screw needs to be frequently adjusted and reset.
MAINTENANCE
Do not modify the product in any way or use accessories
not approved by the manufacturer. Your safety and that
of others may be compromised.
Do not use the product if any switches, guards or
other functions does not work as intended. Return to
an authorised service centre for professional repair or
adjustment.
Do not make any adjustments whilst the saw blade is
in motion.
6 | English
Always make sure the battery pack has been removed
from the product before making adjustments, lubricating
or when doing any maintenance on the product.
Before and after each use, check the product for
damage or broken parts. Keep the product in top
working condition by immediately replacing parts with
spares approved by the manufacturer.
The blade has sharp edges and may also remain hot
yourself from personal injury.
Clean the saw and its accessories from dust regularly,
especially moving parts including the blade guard.
Use a hand brush or vacuum cleaner to remove dust
effectively. Do not use compressed air.
To assure safety and reliability, all repairs, including
changing brushes, should be performed by an
authorised service centre.
WARNING
Do not attempt to disassemble the blade guard assembly
for cleaning or repair. Damaged guards should not be
used. Return to an authorised service centre for repair
or replacement.
WARNING
For greater safety and reliability, all repairs should be
performed by an authorised service centre.
Mitre and bevel angle calibration
If mitre and bevel angle calibration are needed, see pages
Maximum cutting depth stop
blade from cutting into the metal base of the unit.
WARNING

TRANSPORTATION AND STORAGE

When storing the product, remove the battery pack.
Store the product in a secure place that is not accessible
to children.
Clean the product using a brush and vacuum cleaner
before storage.
If you remove the saw blade or keep spares with
the unit, ensure they are in the original packaging to
prevent injury.
To secure the product prior to movement:
The product should be stored at the zero degree mitre
and bevel angle and locked in position. The slide should
be locked. The handle should be locked in the lower
(safe) position with the guards closed.