Ryobi EMS254L Traduction Des Instructions Originales page 97

Varování.
Nástroj nechávejte opravit u kvalifikované osoby.
vykonávali len kvalifikované osoby pomocí originálních
varování v tomto návodu.
nástroj vypnut.
elektrické síti mimo dosah stroje. Uchovávejte mimo
oblast postavení obsluhy.
Before use, thoroughly check the tool, cable, and plug
for any damage or material fatigue. Opravy celého
The lower blade guard should only open when the
blade is lowered to the work piece.
(RCD) s unikajícím proudem 30 mA.
Use only woodworking blades specified in this manual,
which comply with EN 847-1.
listu.
Never use the mitre saw to cut materials other than
those specified in the intended use section in this
manual.
Before work, make a dummy cut without the motor
turned on so the position of the blade, operation of the
guards with respect to other machine parts, and work
piece may be checked.
When performing mitre, bevel or compound mitre cuts,
adjust the sliding fence to ensure the correct clearance
from the blade.
Keep the floor area free of loose materials, such as
chips and cut-offs.
Refrain from removing any cut-offs or other parts of the
work piece from the cutting area whilst the machine is
running and the saw head is not in the rest position.
Long work pieces must be adequately supported.
suitable dust protection mask. Remove deposited dust
thoroughly with a vacuum cleaner.
Do not replace the laser or LED with a different type. Any
repairs must only be carried out by the manufacturer or
authorised service agent.
energie.
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
EL
TR
UK
95