Invacare ScanBed 750 Manuel D'utilisation page 5

Operating the leg section on beds with gas springs
Lift the handle with one hand, while adjusting the leg section to the desired position with the other hand.
Release the handle.
Operating the leg section on SB750, 120 cm width, with Rastofix
To raise the leg section: Lift the leg section to desired height.
NB: Please ensure that both Rastofix brackets are correctly locked in place.
To lower the leg section: Lift the leg section slightly and lower to horizontal.
Always leave the bed in the lowest position. Otherwise there is a risk of squeezing due to
accidental lowering of the mattress support. A person can be seriously injured under the bed
during height adjustment.
Operating the braking castors
Operating castors without central braking system
When the bed is positioned correctly, at least one castor at the head end and one
castor at the foot end must be locked.
1) Braking: Step on the pedal.
2) Releasing the brake: Step on the release pedal.
Operating castors with central braking system
When the bed is positioned correctly, it must be locked.
1) Braking: If the brake is in neutral, step on the red pedal.
2) Releasing the brake: Step on the green pedal, until the brake is in neutral
position.
Operating the steerable castor
The SB750 TM with central braking system may be equipped with a steerable castor.
The steerable castor is operated by means of the central braking pedal.
1) Activating the steering: If the brake is in neutral, step on the green pedal.
2) Deactivating the steering: Step on the red pedal, until the brake is in neutral
position.
Set-off from the castors might under special conditions appear at different types of absorbing floor covering -
including untreated or badly treated floors. In matters of doubt, Invacare® recommends to place a suitable kind of
protection between the castors and the floor.
Release handle
8
Leg section - manual
2)
1)