Device Characteristics; Device Composition; Device Installation; Installation Rules - Atlantic MARADJA Série Notice D'utilisation Et D'installation

Thank you for having chosen this device and placing your confidence in us. The radiator you have just
acquired has been vigorously tested and inspected in order to insure the best quality and provide you with
complete satisfaction.
Some Advice:
Read the Guide before starting installation in order to comply with regulatory requirements. Check the supply
voltage and turn off the electricity before connecting the device.
Keep this Guide, even after installing the device.

Device characteristics:

CAT C : This device complies with NF Electricity Standard performance in the indicated category.
IP24 : This device is protected against water spray
Class II : Double insulation (no ground).
IK08 : Impact strength
: This device complies with European Directive 2002/96/CE (WEEE).

1 - Device Composition

Front

2 - Device Installation

Your device comes with its wall bracket and mounting screws. The choice of screws and anchors depends on
your wall type, so you must ensure that you are using the appropriate screws and anchors based on device
weight.
To facilitate installation, this device has been designed to stand up during connection and bracket installation.
Once the device is standing, you may remove the wall bracket to be used as a template for drilling the holes.

2 .1 - Installation Rules

This device has been designed to be installed in a residential area.
Installation must comply with good practice and applicable standards in the
country where it is installed (NFC 15100 for France).
Observe minimal distances from furniture when placing the device (see
diagram).
If you have a wall covering over foam you must place a shim under the device
support of an equal thickness to the foam in order to maintain the free space
behind the device and not hinder its operation.
Do not install the device:
- In an air flow which may hinder operation (under a controlled mechanical
ventilation, etc.)
- Under a power socket.
- In bathroom volume 1.
Devices used in bathrooms must be installed such that the switches and
other control systems may not be touched by a person in the bath or
shower.
Controls
Wall bracket
Thermostat
Heating Element
Controls
Wall bracket
Heating Element
Front