Controls - Atlantic MARADJA Série Notice D'utilisation Et D'installation

Pilot Wire Connection Test
You may connect the pilot wire if your house has a scheduler or energy manager.
In this case, to check that the scheduling orders are correctly transmitted, conduct the following checks:
Orders
Received power
Signal to
transmit
Mode Obtained COMFORT
For scheduling through the pilot wire or carrier power, freeze protection and load shedding orders have priority.
The delay for switching over from comfort mode to eco mode is about 12 seconds.
2.4 - Lock the Device on its Wall Bracket
- Place the device on bracket S as shown. - Move the device
towards the bracket then lift (arrows 1 and 2).
- Insert the bracket flanges in the holes on the device and lower
(arrow 3).
- Lock by turning the two latches (V) half a turn, your device is
locked.

3 - Controls

 Screen

 Menu  Ventilation
3.1 - Familiarization
First check that the device is on. If it is off, press and hold the
Activate the screen by pushing any key.
You may choose the heating mode by pushing the
Flashing data has not yet been validated.
You may also set comfort and eco mode temperatures using the
For more information regarding the numerous possibilities offered by your device, please consult the following
sections in this Guide.
If you do not use the controls the screen goes into standby mode.
3.2 - Control Screen Description
Ventilation function
Controls locked
No
230V for 3s
COMFORT -1°C COMFORT -2°C
and keys
230V for 7s
and keys

 Equilibrium
key to start.
and keys and validating with
230V -115V negative +115V positive
FREEZE
ECO
PROTECTION
 OK/Validate -
 Consumption Indicator
.
and keys then validating with
Information line
Schedule display
Heating indicator
Display T°C
Modes
LOAD
SHEDDING
HEATING STOP
Stop heating
.