7) Locking the controls
Knobs
and
can be locked in position or its range restricted to pre-
vent inappropriate use (by children, etc..).
a) Unhook the appliance from the wall bracket.
b) Detach pins P from their supports on the rear of the
thermostat box.
c) Select position B to lock the knob or position L to restrict its
adjustment range.
Select one of the positions M to lock the cursor in the desired
mode.
8) Programming mode
The appliance is fitted with a thermostat that can be controlled via
the control wire. It recognises the following commands:
- COMFORT
- ECO
- FROST PROTECTION
- STOP
To activate Programming mode, set cursor
You can therefore programme the Comfort and Eco temperature periods by connecting the control wire
to a programming unit or another appliance fitted with a time clock to save on energy.
NB: If no commands are received via the control wire, the appliance operates in Comfort mode.The frost-
free and power interruption commands are prioritised over the Eco and Comfort modes.When switching
from Comfort to Eco mode, the switchover time is around 12 seconds.
- There is no point in setting the appliance to maximum, the room temperature will not rise any quicker.
- When you are airing a room, switch off the appliance by setting cursor
- If you will be away for several hours, consider reducing the temperature.
For an absence of:Less than 2 hours
2 to 24 hours
More than 24 hours or in summer : Set knob
- If you have several appliances in one room, let them operate simultaneously. In this way, you will obtain
a more homogeneous temperature without increasing your electricity consumption.
:Temperature set by knob
:Temperature set by knob
:Ambient temperature maintained at around 7°C.
:The appliance immediately switches off (used for power cutoff).
to
1
A
DVICE ON USE
.
.
.
: Don not alter the controls.
: Set cursor
1
to
B
L
P P
to
.
1
to
.
.
1
M