How To Install The Appliance - Atlantic Tatou Notice D'utilisation Et D'installation

2) How to install the appliance ?

2-1) Fixing the wall bracket:
-
Remember to fit the wall spacers between the bracket and the
wall (except on vertical models).
2-2) Connecting the appliance.
- The appliance must be supplied with 230V
50Hz.
- It is connected to the electricity supply by
means of a 3 core cable (Brown= Live, Blue=
Neutral, Black= control wire) via a connection
box. In damp areas such as bathrooms and kit-
chens, the connection box must be installed at
least 25 cm above the floor.
- The installation must include a double-pole
cutout with a contact opening distance of at
least 3mm.
- The appliance must not be earthed.
Do not connect the control wire (black) to the
earth.
- If the supply cable is damaged, it must be replaced by the manufacturer, his after-sales service or a simi-
lar person of qualification in order to avoid a danger.
- If a controlling or controlled appliance is protected by a 30mA differential (e.g: in a bathroom), the sup-
ply to the control wire must also be protected by the same differential.
Table of the commands that the appliance can receive via a control wire
Command
received
Oscilloscope
Réf/Neutral
Resultant
heating
temperature
2-3) Locking the appliance on the wall bracket.
- Position the appliance on bracket S as shown in the diagram.
- Lock bolt V.
(To be measured between the control wire and Neutral)
Complete
No current alternation
COMFORT
Panel heater cable
Phase=brown
Neutral=blue
Pilot wire=Black
1st case: only one heater
2nd case: Slave heater
3rd case: Master heater
Half negative
alternation -115V
230V
FROST
ECO
PROTECTION
1
PHASE
NEUTRAL
Three possible cases
The pilot wire end is insulated
and not further connected
To the appliance with cassette or
programming unit.
To pilot wire of an electronically
controlled appliance
Half positive
alternation +115V
POWER
CUTOFF
v
S
2
Electricity
grid