Installing The Device - Atlantic 2012 Notice D'utilisation Et D'installation

Radiateur sèche-serviettes électronique
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 3
The device you have just purchased was submitted to many tests and checks ensuring its quality. We
thank you for your choice and trust.We hope you will be fully satisfied.
A few recommendations:
Read the instructions before installing the device.
Power the device off before intervening on it, and check the power supply voltage.
Store the instructions, even after installing the device.
1) Location of the device
- This device was designed to be installed in residential
premises. In any other case, please call your distributor.
- Installation must be ensured according to the rules of
the art, and in compliance with the standards currently
enforced in the installation country.
- Locate the device within minimum distances from
obstacles.
Do not install the device:
In a draft likely to disturb its regulation
(under centralised mechanical ventilation, etc...).
Under a fixed mains outlet.
Inside volume 1 in bathrooms.
Inside volume 2 if handling the controls are accessible to
persons using the shower or the bath tub.
Except in the UK, please refer to the IEE Regulations 601-06-
01 and 601-08-01 (B57671),
Overall height
Power
(H) (mm)
500 W
1013
750 W
1464
2) How to install the device ?
1/ Unfasten the flaps on the lid and position it against the wall with the
lower flap folded back and placed on the floor or at the desired
installation height. Mark off the 4 drill holes through the packaging,
without drilling them, and then remove the packaging.
2/ Carefully mark the 4 drilling points with a pencil (draw a cross, 2cm
wide).
3/ Drill the 4 holes.
4/ Screw the sleeve in place. Fit the screws with the washers provided.
5/ Screw the pins on the tubes without locking them. Check they are correctly positioned by inserting them
in the sleeves, with the appliance. After finding the right position, tighten the screws on each pin.
6/ Place the appliance on the wall, in the sleeves.Tighten all the locking screws. Fit the caps on the ends of
the pins.
I
NSTALLING THE DEVICE
Widthr (L)
Thickness (mm)
(mm)
480
67
82
6
Volume
3
Volume
Volume
2
H
281 mini
3 m
1
150
L
mini
150
mini
200 mini

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

2012 galbé

Table des Matières