Installing The Device - Atlantic Zanzibar Classique Notice D'utilisation Et D'installation

The device you have just purchased was submitted to many tests and checks ensuring its quality. We
thank you for your choice and trust.We hope you will be fully satisfied.
A few recommendations:
Read the instructions before installing the device.
Power the device off before intervening on it, and check the power supply voltage.
Store the instructions, even after installing the device.
Characteristics of the device:
Cat B or C : Device complying with NF standard Electricity Performance for the category indica-
ted.
IP24 : Device protected against water projections.
Classe II : Dual insulation.
1) Location of the device
- This device was designed to be installed in residential pre-
mises. In any other case, please call your distributor.
- Installation must be ensured according to the rules of the
art, and in compliance with the standards currently enfor-
ced in the installation country.
- Locate the device within minimum distances from obsta-
cles.
Do not install the device:
In a draft likely to disturb its regulation (under centralised mechanical ventilation,
etc...).
Under a fixed mains outlet.
Inside volume 1 in bathrooms.
Inside volume 2 if handling the controls are accessible to per-
sons using the shower or the bath tub.
2) How to install the device
The installation template is printed on the packaging.
1) Unfasten the carton's flaps and place it against the wall with the lower flap folded
back and resting flat on he floor. Prick out the four drill holes though the packa-
ging (without drilling) and then remove the packaging.
2) Carefully mark the drilling points with a pencil (draw a cross, 4cm wide).
3) Drill the four holes.
4) Position the four hooks and screw them tight.
5) Attach the appliance and lock it in place.
(shown on the machine's information label)
I
NSTALLING THE DEVICE
Volume
3
Volume
Volume
2
H
GB
3 m
1
150 mm mini
L
150 mm mini
200 mm mini