Turbo Mode; Locking Commands - Atlantic Zanzibar Classique Notice D'utilisation Et D'installation

3) Standby (Hors Gel) Mode
It is the mode enabling to maintain a temperature of approximately 7°C in the room in case of prolonged
absence from the house.
a) Leave switch on the Marche position.
b) Set the knob to

4) Turbo mode

It is the mode enabling to set the device into Forced Operation, ensuring prompt temperature increase
in the room over the time defined (maximum power for conventional models and fan activation point
for models with ventilating fan).
a) Leave the switch
b) Select the time for the Turbo using the knob
c) Press the command
The TURBO mode can be interrupted manually before the end of the time set. In order to do this,
press the command
NB: On a piloted or independently programmed appliance, only the Stop and Anti-frost instructions have
priority when the TURBO mode is activated (the other instructions are ineffective).

5) Locking commands

It is possible to lock the knob
dren...).
Locking the knob:
a) Set the knob to the position required.
b) Using a small-size flat-blade screwdriver, pull the knob's cap (1).
c) Detach pin P from its stand using a cutting tool.
d) Set pin P in the alignment of arrow B (2).
e) Refit the cap.
Limitation of the knob's use range:
a) Using a small-size flat-blade screwdriver, pull the knob's cap (1).
b) Remove the two P pins from their stand using a cutting tool.
c) Position the two P pins at each end of the operating range desired (3).
d) Refit the cap.
1
- When ventilating the room, stop the device by setting the switch
- If you leave for several hours, lower the temperature.
Leaving for: Less than 24 hours
More than 24 hours or during summer :set the temperature knob to
.
on the Marche position.
and
, the indicator
again.
or restrict its use, preventing untimely handling of the device –(chil-
2
R
ECOMMENDATIONS OF USE
.
light.
P
B
:do not touch the controls.
3
P
L L
to the Arrêt position.
.