Sigfox BREATH - Guide utilisateur / User guide version V1.0.0
This mix gas used for calibration is a 22 VOCs compounds with a similar concentration to an indoor residential environment.
Here under the gas lis and their ratio inside the mix:
Compound
n-Hexane
n-Nonane
n-Decane
FR
n-Undecane
1-Octane
1-Decene
Cyclohexane
m-Xylene
EN
Ethylbenzene
1,2,4-Trimethylbenzene
n-Propylbenzene
α-Pinene
2. DEVICE OPERATIONS
2.1.
Operating modes
The device has several operating modes:
MODE COMMANDE
2.1.1 PARK mode
The product is delivered in PARK mode, it is in standby mode and its consumption is minimal. To switch the product out of the Park mode press
the button for a duration higher than 5 seconds. The green LED illuminates to indicate the detection of the push button and then flashes quickly
during the product starting phase.
The device then sends its configuration and data frames.
2.1.2 COMMAND mode
This mode allows the user to configure the registers of the product.
To enter in this mode, plug the micro-USB cable and use the IoT Configurator or AT command. Exit from command mode is done when USB
is disconnected, using the "disconnect" button in the IoT Configurator or with an ATO command. The product will return in its previous state,
PARK or PRODUCTION.
2.1.3 PRODUCTION mode
This mode allows the user to operate the product in its finale use.
Ratio
1
1
1
0.1
0.01
1
0.1
10
1
0.1
0.1
1
Envoi commande
sur lien série
MODE PRODUCTION
Compound
Ratio
n-Pentanal
0.1
n-Hexanal
1
Iso-propanol
0.1
n-Butanol
1
2-Butanone
0.1
3-Methyl-3-butanone
0.1
4-Methyl-2-pentanone
0.1
n-Butylacetate
10
Ethoxyethylacetate
1
1,2-Dichloroethane
1
MODE PARC
Appui long sur le
bouton (5 sec)
Page
40
of 52