Cleaning And Storage; Troubleshooting; Technical Data - DS Produkte YH-09 Mode D'emploi

Cleaning and Storage

CAUTION!
■ Pull the mains plug out of the socket and allow the device to cool down completely
before doing any cleaning!
■ Do not use any caustic or abrasive cleaning agents for cleaning. These can damage
the surface.
• Dust down the device if necessary or wipe it down with a damp cloth if necessary.
Then wipe it dry with a dry cloth.
• When not in use, the device should be stored in a clean, dry place which is protected
from dust and is not accessible to children and animals.

Troubleshooting

If the device does not work properly, fi rst check whether you are able to rectify the prob-
lem yourself.
Do not attempt to repair a defective electrical device yourself!
Problem
The device does not
work.
Smell produced
when device is fi rst
used

Technical Data

Article:
Model:
Voltage supply:
Power:
Protection class:
15
Possible cause/solution
• Is the mains plug inserted in the socket correctly?
• Is the socket defective? Try another socket.
• Check the fuse of the mains connection.
• Is the main switch (11) and the
level 1 (10) in position I?
• The safety switch has been triggered. Check whether the
device is currently on a fl at surface.
There are production residues in / on the device. This is
normal and will not occur again. Make sure the room is well
ventilated, e.g. with wide-open windows!
01505
YH-09
220 – 240 V~ 50 Hz
max. 1500 W
II
EN
switch for heating