Mains Fuses; Electrical Connection - FriFri Pasta 311 Manuel D'installation

2.5 Mains fuses

Type
311
Power 7.5 kW
3N 400V 11 A

2.6 Electrical connection

The electrical connection of the machine must be done by an electrician or a qualified person who can ensure that the
installation meets the required standards. Proceed as follows:
a) Check if the specifications of the electrical mains correspond to those given on the rating plate. This plate is located
on the control panel inside the door.
b) Connect according to IEC or CEI 335-1 standards and local regulations, i.e.: Fit a mains plug to the connection
cable, corresponding to the power of the rated current. Plug into the mains socket. The plug must be accessible
after installing the fryer. The manufacturer recommends to connect the fryer to a fault-current protective switch (for
machines which exceeds 10mA of dispersion current). For permanent installation: connect to a main switch with all
the poles isolated; minimum distance of the contacts 3 mm.
c) Allows he connection of the ground (Earth connection). It is essential for your installation. Supplemented by a
differential device, it protects the users when an electrical defect occurs on an appliance. The fault current
runs out towards the ground and causes the release of the differential.
d) If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.