General Information - Beurer EM 49 Mode D'emploi

5. Use
5.1 Notes on use
• The device switches itself off automatically if it is not used for
one minute (automatic switch-off). When the unit is switched on
again, the LCD screen displays the menu selection and the most
recently used menu flashes.
• A brief acoustic signal is output when a valid button is pressed.
Two brief acoustic signals are output when an invalid button is
pressed.
• You can pause the stimulation at any time by briefly pressing the
ON/OFF button . To continue the stimulation, briefly press the
ON/OFF button again and set the desired impulse intensity
again.
5.2 Starting application
Step 1: Look for a suitable program from the program tables (see
section „6. Program overview").
Step 2: Place the electrodes on the desired area for treatment (for
positioning suggestions see section „6.4 Information regarding the
positioning of electrodes") and connect them to the device.
Step 3: Press the ON/OFF button
Step 4: Press the MENU button to navigate through the
/ menus and press the ENTER button to confirm
your selection.
˄/˅
Step 5: Use the setting buttons to select the program number
you want and press the ENTER button to confirm your selection.
At the start of the stimulation treatment, the impulse intensity of
and is set to 00 by default. No impulses are sent to the
electrodes yet.
Step 6: Use the left and right
to select the impulse intensity you want. The indicator for impulse
to switch on the device.
˄/˅
setting buttons for
intensity in the display changes accordingly. If the program is in a
pause phase, the intensity cannot be increased.

General information

If you wish to return to the previous selection menu, press the
MENU button. By holding down the ENTER button, you can skip
individual setting steps and start directly with the stimulation
treatment.
Keylock
Locks the buttons to avoid them being pressed
unintentionally.
1. To activate the keylock, hold down the
symbol is visible in the display (approx. 3 seconds).
2. To deactivate the keylock, hold down the
symbol disappears from the display (approx. 3 seconds).
Pausing application
You can pause the stimulation at any time by briefly pressing the
ON/OFF button
ON/OFF button
again.
/
and
26
button until the
. To continue the stimulation, briefly press the
again and set the desired impulse intensity
button until the