Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
˄/˅
3. Use the
setting buttons to select the impulse frequency you
want and use the ENTER button to confirm.
˄/˅
4. Use the
setting buttons to select the impulse width you want
and use the ENTER button to confirm.
˄/˅
5.Use the
setting buttons to select the treatment time you want
and use the ENTER button to confirm.
˄/˅
6.Use the left and right
select the impulse intensity you want.
TENS 14 program
The TENS 14 program is a burst program that you can also
customise. Various impulse sequences run in this program. Burst
programs are suitable for all areas of application to be treated with
changing signal patterns (to minimise the level of accustoming to
the treatment). In this program you can set an impulse width of
between 80 and 250 µs.
1. Place the electrodes on the desired area for treatment (for
positioning suggestions see electrode positions in section 6.4)
and connect them to the device.
2. Select the TENS 14 program as described in section "5.2 Starting
application" (step 3 to step 5).
˄/˅
3. Use the
setting buttons to select the impulse width you want
and use the ENTER button to confirm.
˄/˅
4.Use the
setting buttons to select the treatment time you want
and use the ENTER button to confirm.
˄/˅
5.Use the left and right
select the impulse intensity you want.
TENS 15 program
TENS 15 is a program that you can also customise. In this program,
you can set the impulse frequency to between 1 and 150 Hz.
The impulse width changes automatically during the stimulation
treatment.
setting buttons for
and
setting buttons for
and
1. Place the electrodes on the desired area for treatment (for
positioning suggestions see electrode positions in section 6.4)
and connect them to the device.
2. Select the TENS 15 program as described in section "5.2 Starting
application" (step 3 to step 5).
˄/˅
3. Use the
setting buttons to select the impulse frequency you
want and use the ENTER button to confirm.
to
˄/˅
4.Use the
setting buttons to select the treatment time you want
and use the ENTER button to confirm.
5.Use the left and right
select the impulse intensity you want.
EMS 33 program
EMS 33 is a program that you can also customise. In this program,
you can set the impulse frequency to between 1 and 150 Hz and the
impulse width to between 80 and 320 µs.
1. Place the electrodes on the desired area for treatment (for
positioning suggestions see electrode positions in section 6.4)
and connect them to the device.
2. Select the EMS 33 program as described in section "5.2 Starting
application" (step 3 to step 5).
˄/˅
3. Use the
setting buttons to select the impulse frequency you
want and use the ENTER button to confirm.
˄/˅
4. Use the
setting buttons to select the impulse width you want
and use the ENTER button to confirm.
˄/˅
5.Use the
setting buttons to select the treatment time you want
to
and use the ENTER button to confirm.
6.Use the left and right
select the impulse intensity you want.
EMS 34 program
EMS 34 is a program that you can also customise. In this program,
you can set the impulse frequency to between 1 and 150 Hz and
the impulse width to between 80 and 450 μs. You can also set the
31
˄/˅
setting buttons for
˄/˅
setting buttons for
and
to
and
to
Publicité
Table des Matières
