Maintenance
Replace the air filters.
Examine the spark plug.
Do the service on the drive system for grinding discs.
Do a check of the connection between chassis and grinding head.
To clean the product
CAUTION: A blocked air intake decreases
the performance of the product and can
cause the engine to become too hot.
•
Remove blockage from all air openings. The product
must always have sufficiently cool temperature.
•
Do not use chemicals to clean the product.
•
Do not clean electrical components with water.
•
Always clean all the equipment at the end of the
work day. Clean the components at the bottom
surface of the grinding head with a high-pressure
washer.
CAUTION: Do not point the high-
pressure washer directly at seals or
connection points.
To clean the battery and the battery charger
CAUTION: Do not clean the battery or the
battery charger with water.
•
Make sure that the battery and the battery charger
are clean and dry before you put the battery into the
battery charger.
•
Clean the battery terminals with compressed air or
use a soft and dry cloth.
•
Clean the surfaces of the battery and the battery
charger with a soft and dry cloth.
24
Daily
To clean the oil cooling fins
•
Clean the oil cooling fins with a brush or with
compressed air.
To do a general inspection
•
Make sure that nuts and screws are tight.
•
Make sure that the grinding discs turns smoothly.
•
Make sure that the grinding discs are clean.
•
Make sure that the lock mechanism for the tool plate
is clean and turns easily.
Each
Each 6
Weekly
12-36
months
months
X
X
*
1268 - 001 - 24.10.2019
O