Husqvarna Duratiq 6 Propane Manuel D'utilisation page 26

3. Remove the propane tank from the product.
4. Fill the propane tank with new propane or replace
the propane tank.
5. If the propane tank is filled too much, use a
screwdriver at the propane tank valve to release
unwanted propane. Release the propane in a safe
procedure, refer to Propane safety on page 10 .
6. Install the filled/new propane tank to the product.
To connect and disconnect the propane
Refer to
tank on page 17 .
7. If the weather is cold, keep the product indoors
before use to warm up the propane tank. You can
also use a propane tank heat blanket to warm up the
propane tank.
To do a check of the oil level
CAUTION: A too low oil level can do
damage to the engine. Do a check of the oil
level before you start the product.
1. Put the product on level ground.
2. Remove the oil tank cap with the attached dipstick.
3. Clean the oil from the dipstick.
4. Put the dipstick fully into the oil tank to give a correct
picture of the oil level.
5. Remove the dipstick.
6. Examine the oil level on the dipstick.
7. If the oil level is low, fill with engine oil and do a
check of the oil level again.
To replace the engine oil
If the engine is cold, start the engine for 1–2 minutes
before you drain the engine oil. This makes the engine
oil warm and easier to drain.
WARNING: Do not operate the engine for
more than 1–2 minutes before you drain the
engine oil. The engine oil becomes very hot
and can cause burn injuries. Let the engine
become cool down before you drain the
engine oil.
WARNING: If you spill engine oil on your
body, clean with soap and water.
1. Put a container below the oil drain plug.
26
2. Remove the oil drain plug.
3. Drain the oil into the container.
4. Attach the oil drain plug and tighten it.
5. Fill with new oil. Refer to
35 .
6. Start the engine and let it run at idle speed for 3
minutes.
7. Stop the engine and make sure that the oil drain plug
does not leak.
8. Do a check of the oil level. Refer to
the oil level on page 26 .
Note: For safe disposal of used engine oil, refer to
Disposal on page 34 .
To replace the oil filter
1. Drain the engine oil, refer to
oil on page 26 .
2. Turn the oil filter counterclockwise to remove it.
3. Lightly lubricate the rubber seal on the new oil filter
with new oil.
Technical data on page
To do a check of
To replace the engine
1268 - 001 - 24.10.2019