Husqvarna Duratiq 6 Propane Manuel D'utilisation page 25

Drive system for grinding head
The drive system for the grinding head is a closed
system. If you have problems with the drive system of
the grinding head, speak to your Husqvarna service
agent.
Product battery
The product battery is in the inspection hatch on the
To open the inspection hatches on
product. Refer to
page 17 .
The product battery starts to charge when the battery
switch is closed. The battery switch must be closed
when the product is in operation. The battery switch
must be open when the product is not in operation,
during transportation and storage.
To fill the water tank with water
The water level in the water tank is too low when the
button for the Mist Cooler System (A) on the control
panel is yellow. The indicator for Mist Cooler System (B)
in the display is also yellow when the water level is too
low.
B
1268 - 001 - 24.10.2019
1. Open the storage hatch near the engine. Refer to
open the storage hatches on page 16 .
2. Remove the water tank cap.
3. Fill the water tank with cold water.
To examine the propane tank and lines
CAUTION: Examine the propane tank and
lines each time the propane tank is filled
and/or connected to the product.
1. Make sure that the propane tank has no damages.
2. Connect the propane tank to the product. Refer to
connect and disconnect the propane tank on page
17 .
3. Apply a soap mixture as a spray at all lines and
connections. For soap mixture use 50% soap and
50% water.
4. If there is a leak, there will be bubbles on the lines
and the connections. Speak to an approved service
agent.
To fill the propane tank
CAUTION: Examine the propane tank and
lines each time the propane tank is filled
and/or connected to the product. Refer to
examine the propane tank and lines on page
25 .
Do not fill the propane tank too much. The propane tank
can hold a maximum of 9 kg/20 lbs of propane. A full
A
propane tank must not weigh more than 21.8 kg/48 lbs.
If the propane tank is filled too much, frost shows on the
propane lines or on the regulator.
1. Stop the product. Refer to
control panel on page 19 .
2. Make sure that the propane tank valve is closed.
To
To
To stop the product with
To
25