Husqvarna Duratiq 6 Propane Manuel D'utilisation page 17

3. Fold up the storage hatch (C) to open the storage
hatch near the engine.
To open the inspection hatches
The product has 1 inspection hatch on each side of the
product.
• Pull out the inspection hatch cover to open the
inspection hatch.
To connect the battery
• Make sure that the wires are firmly connected to the
correct terminals, red (+) first, black (-) second.
Disconnect the battery in reverse order.
• Make sure that the bracket that holds the battery in
place is correctly assembled, so that the battery
can't move during operation.
To connect and disconnect the propane
tank
CAUTION: Make sure to use the correct
propane tank type. An incorrect propane
tank can cause damage to the product.
Technical data on page 35 .
Refer to
1268 - 001 - 24.10.2019
If the propane tank is connected and the product is not
in operation, close the propane tank valve.
1. Make sure that the propane tank is tightly held in
C
2. Connect the propane hose from the product to the
3. Make sure that the propane hose is correctly
4. Make sure the all couplers are in line. Tighten the
5. Turn the propane tank valve counterclockwise until it
6. Do a soap test on all propane lines. Refer to
7. Disconnect in the opposite sequence.
To connect the product to a water hose
Make sure that the water supply is only on during
operation.
position by the lock and the holder plate. The
propane tank cannot move when the propane tank is
correctly installed.
propane tank.
connected to the fuel valve on the engine.
couplers by hand to connect the propane tank to the
product.
CAUTION: Do not use a tool to complete
the connection of the propane tank to the
product. The couplers can be damaged.
stops to start the flow of the propane.
examine the propane tank and lines on page 25 .
To
17