4. To attach the oil filter, turn it clockwise until the
rubber seal is in position. Tighten the oil filter ⅔ turn
more.
5. Fill with new oil. Refer to
35 .
6. Start the engine and let it operate at idle speed for 3
minutes.
7. Stop the engine and make sure that the oil filter does
not leak.
8. Do a check of the oil level.
To replace the air filters
CAUTION: Do not operate the product with
the air filters removed.
Note: Do not clean the air filters. Replace the air filters
when it is necessary.
1. Open the 2 clamps (A) of the air filter housing (B)
and remove the air filter housing.
A
B
2. Replace the outer air filter (C) and the inner air filter
(D).
D
C
1268 - 001 - 24.10.2019
Technical data on page
3. Install the new air filters in opposite sequence.
Note: If the 2 clamps of the air filter housing cannot
be closed, the outer air filter is not correctly installed.
To examine the spark plug
CAUTION: Always use the recommended
spark plug type. Incorrect spark plug type
can cause damage to the product.
•
Examine the spark plug if the engine is low on
power, is not easy to start or does not operate
correctly at idle speed.
•
To decrease the risk of unwanted material on the
spark plug electrodes, obey these instructions:
a) Make sure that the idle speed is correctly
adjusted.
b) Make sure that the fuel mixture is correct.
c) Make sure that the air filter is clean.
•
If the spark plug is dirty, clean it and make sure that
the electrode gap is correct, refer to
on page 35 .
•
Replace the spark plug if it is necessary.
Technical data
27