Troubleshooting - Husqvarna Duratiq 6 Propane Manuel D'utilisation

Problem
The product does not
start.
The engine does not
start.
The engine starts but
stops after a short
time.
The engine starts but
stops after 1-2 mi-
nutes.
The engine is on but
the grinder does not
start.
The engine stops.
The product smells of
smoke.
28

Troubleshooting

Cause
The battery is not charged.
The emergency stop button is engaged.
The safety switch is open in the electrical en-
closure.
The propane tank is empty.
The propane tank valve is closed.
The ignition is defective.
The propane tank is almost empty.
The air filter is clogged or dirty.
The belt is broken.
The clutch disengages.
The emission values are higher than permit-
ted levels.
The clutch disengages.
Solution
Charge the battery.
Turn the emergency stop button on the con-
trol panel control clockwise to disengage.
Close the safety switch to complete the cir-
cuit.
Fill or replace the propane tank.
Turn the propane tank valve to open the pro-
pane tank.
Speak to an approved service agent.
Fill or replace the propane tank.
Replace the air filter.
If the problem continues, speak to an ap-
proved service agent.
If the belt is broken, let a service center re-
place it.
Turn one of the grinding discs by hand. If all
grinding discs rotate together, the belt is not
damaged. If one grinding disc rotates freely,
then the belt is broken.
Speak to an approved service agent.
Examine if the indicator on the emission con-
trol is on. Speak to an approved service
agent.
Make sure that the speed of the grinding
discs is not between 420 and 675 rpm.
1268 - 001 - 24.10.2019