Husqvarna Duratiq 6 Propane Manuel D'utilisation page 13

14. Turn the emergency stop button on the control panel
clockwise to make sure that the emergency stop
button is disengaged.
15. Remove the support wheel. Refer to
support wheel in position for short distance
transportation on page 32 .
Diamond tools
There are many different types and configurations of
diamond tools for the product. Metal bonded diamond
tools are used for removal of material and resin bonded
diamond tools are used to polish surfaces. Select the
correct diamond tools for the surface. Speak to your
Husqvarna dealer or go to www.husqvarnacp.com for
support to select the correct tool.
Disc holder alternatives for diamond tools
• Use a Redi lock disc holder to attach metal bonded
diamond tools.
• Use a resin disc holder to attach plastic bonded
diamond tools.
Full set and half set of diamond tools
The configuration of the diamond tool segments has an
effect on the end quality of the surface. The
configuration also has an effect on the operation rate of
the product.
• Full set of diamond tools: This configuration is
applicable for a flat floor finish.
1268 - 001 - 24.10.2019
•
To replace the diamond tools
To set the
1. Push the ON/OFF button (A) on the control panel
2. Push the emergency stop button (B) on the control
3. Set the handle in servicing position. Refer to
4. Adjust the weights to a rearward position. Refer to
Half set of diamond tools: This configuration is
applicable when a flat floor finish is not necessary.
WARNING: Use protective gloves, as
diamond tools can become very hot.
WARNING: Use approved respiratory
protection when you replace the diamond
tools. The dust below the grinding head is
dangerous to your health.
WARNING: Use the dust extractor when you
replace the diamond tools. The dust
extractor will decrease the dust that can
cause health problems.
CAUTION: All the grinding discs must
always have the same number and type of
diamonds. The height of the diamonds must
be the same on all grinding discs.
stop the product.
B
panel.
positions on page 15 .
To adjust the weights on page 21 .
A
Handle
13