Symbols On The Product - Husqvarna Soff-Cut 150 Manuel D'utilisation

13. Blade block
14. Blade block cover
15. Dust extractor connection
™
16. Lexan cover
17. Plug for the dust extractor connection
18. Starter rope handle
19. Fuel valve and Engine ON/OFF switch
20. Choke control
21. Throttle trigger
22. Air cleaner inlet
23. Air filter cover
24. Muffler cover
25. Fuel tank cap
26. Fuel tank
27. Dipstick/oil tank
28. Oil drain plug
29. Operator's manual

Symbols on the product

WARNING: Be careful and use the product
correctly. This product can cause serious
injury or death to the operator or others.
Read the operator's manual carefully and
make sure that you understand the
instructions before you use this product.
Use hearing protection, eye protection and
respiratory protection. Refer to
protective equipment on page 8 .
All displacement of the machine outside the
cutting area shall be carried out with the tool
not in rotation.
Risk of cut injuries. Keep all body parts
away from the cutting blade.
The dust can cause health problems. Use
an approved respiratory protection. Do not
breathe exhaust fumes. Do not use a
combustion engine product indoors or in
areas that do not have sufficient airflow.
Risk of pinching. Keep body parts away from
moving parts.
Keep body parts away from the cutting blade
and other moving parts.
714 - 004 - 06.07.2021
Personal
Note: Other symbols/decals on the product refer to
certification requirements for other commercial areas.
The arrow on the blade guard shows the
direction of rotation of the cutting blade.
Always stop the engine and let it become
cool before you refuel.
Unleaded gasoline with a maximum of 10%
ethanol.
Explosive fuel can cause fires and severe
burns.
Always stop the engine before you fill the
fuel tank. Keep ⅝ in. (16 mm) at the top of
the fuel tank to let the expand. Read the
Operator's Manual and the Kohler engine
manual.
Hot muffler, do not touch.
ON, start
Off, stop
Fill engine oil to correct level.
Read and understand the manual for the
dust extractor.
To lift the product, attach lifting equipment to
the lift point on the product.
Release the handle to
lower the blade by gravity.
To prevent damage to the
blade, hold the product
tightly and lower the blade
carefully.
5