Functional Description; Removing/Inserting The Battery - Milwaukee M18 FUEL Manuel De L'utilisateur

• Always observe that the lower guard is covering
the blade before placing saw down on bench or
floor. An unprotected, coasting blade will cause the
saw to walk backwards, cutting whatever is in its
path. Be aware of the time it takes for the blade to
stop after switch is released.
• To reduce the risk of injury in ap-
WARNING
plications that produce a consid-
erable amount of dust, use an OSHA compliant
dust extraction solution in accordance with the
solution's operating instructions.
• Always use common sense and be cautious when
using tools. It is not possible to anticipate every
situation that could result in a dangerous outcome.
Do not use this tool if you do not understand these
operating instructions or you feel the work is beyond
your capability; contact Milwaukee Tool or a trained
professional for additional information or training.
• Maintain labels and nameplates. These carry
important information. If unreadable or missing,
contact a MILWAUKEE service facility for a free
replacement.
•
Some dust created by power sanding,
WARNING
sawing, grinding, drilling, and other
construction activities contains chemicals known to
cause cancer, birth defects or other reproductive
harm. Some examples of these chemicals are:
• lead from lead-based paint
• crystalline silica from bricks and cement and other
masonry products, and
• arsenic and chromium from chemically-treated
lumber.
Your risk from these exposures varies, depending on
how often you do this type of work. To reduce your
exposure to these chemicals: work in a well ventilated
area, and work with approved safety equipment, such
as those dust masks that are specially designed to
filter out microscopic particles.
SYMBOLOGY
Volts
Direct Current
No Load Revolutions per Minute (RPM)
UL Listing for Canada and U.S.
C US
SPECIFICATIONS
Cat. No. ..................................................... 2830-20
Volts.............................................................. 18 DC
Battery Type .................................................M18™
Charger Type................................................M18™
Recommended Ambient
Operating Temperature ......................0°F to 125°F
No Load RPM ..................................................5800
Blade Size ..................................................... 7-1/4"
Arbor ......................................................... Diamond
Depth of Cut at 90° ................................. 0 to 2-1/2"
Depth of Cut at 45° ................................. 0 to 1-7/8"

FUNCTIONAL DESCRIPTION

11
10
9
8
7
19
18
17
1. Lock-off button
2. Trigger
3. Handle
4. Depth adjusting lever
5. Lower guard lever
6. Lower guard arrow
7. Blade bolt
8. Blade flange
9. Sight lines
10. Upper guard
ASSEMBLY
Recharge only with the charger
WARNING
specified for the battery. For spe-
cific charging instructions, read the operator's
manual supplied with your charger and battery.

Removing/Inserting the Battery

To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
Always remove battery pack before
WARNING
changing or removing accessories.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
4
2
1
5
6
12
13
15
16
11. Top handle
12. Spindle lock button
13. Bevel adjusting lever
14. Rip fence adjusting
knob
15. Rip fence slot
16. Lower guard
17. Shoe
18. Wrench/Storage
19. Rafter hook
3
4
14