Technical Specifications; Safety Instructions - Life & Mobility ROXX Mode D'emploi

Inspired by life

Technical specifications

Seat width 37 to 60 cm (in steps of 3 cm)
Seat depth 42 to 58 cm
Seat height 38 to 60 cm (in steps of 1 cm)
Armrest height 18 to 27 cm (in steps of 1,5 cm)
Width of wheelchair 60 to 80 cm (in steps of 5 cm)
Width of wheelchair 31 cm
folded (incl. wheels)
Seat angle 0˚ or adjustable
Backrest angle Once-only adjustment (0 – 180˚)
Continuously adjustable
(85 – 105˚ / 115˚)
Backrest height Adjustable in 1 cm steps
Camber angle 2˚
Lower leg length 35 - 45 cm / 40 - 55 cm / 50 - 65 cm
Total weight From 25 kg
Lift weight From 10 kg
Max. weight of 160 kg
occupant
Complies with EN 12182 / EN 12183 / ISO 7176-19:2008
Life & Mobility recommends using the Roxx in an
ambient temperature of between -5 °C and +40 ° C.
Service and technical support
Consult your dealer if you have questions about
specific adjustments, maintenance or repair. Always
have the serial number available. You can find this on
the CE sticker on the wheelchair (A).
Expected service life
Life & Mobility assigns a service life of 7 years to
this product. This means that during this period, the
product is fixable, safe and usable.
The statement above is only applicable if the user
uses the product in the manner that Life & Mobility
intended, marked with CE and including any original
accessories.
EN8
Maximum user weight 140 kg Maximum user weight 160 kg
Logistiekweg 7
7007 CJ DOETINCHEM
T +31 (0)314 328000
* R 1 9 0 7 8 9 8 *
E info@life-mobility.com
A

Safety instructions

Life & Mobility accepts no liability for damage or
injury caused by negligence or non-compliance with
the safety instructions.
Dependent on the specific circumstances or acces-
sories used, supplementary safety instructions can be
required.
General
n Never change the construction of the wheelchair.
n Only use original Life & Mobility parts and acces-
sories. These are tested and safe.
Markings on the wheelchair
n Markings, safety symbols and instructions are
displayed on this wheelchair. They must not be co-
vered or removed. They must remain on and be
clearly visible throughout the life of the wheelchair.
Assembly and adjustment
n Before using the wheelchair, check that all of the
components of the wheelchair are correctly and
securely installed.
n Ensure that the push-handles, the backrest height,
the armrests, the lower leg length and the head-
rest, if present, are adjusted to the right height.
n Ensure that there is a minimum distance of 5 cm
between the legrests and the floor.
n Check the dimensions and correctly adjust them in
the manner described in this manual.
EN9