Assembly Of The Morcellator Set With Trocar Cannula (Option 2) - Nouvag TCM 3000bl Mode D'emploi

TCM 3000 BL - Morcellator
5.2.2

Assembly of the Morcellator set with Trocar Cannula (option 2)

Using the Trocar Cannula
The Trocar Cannula is used instead of the protective tube. The integrated valve flap prevents the escape
of gas when instruments are moved in and out.
The nose of the Trocar Cannula partially extends beyond the cutter tube to protect organs in the ab-
dominal cavity from the sharp blade. This requires the Morcellator to be rotated under visual supervision
(endoscopy) so the nose of the Trocar Cannula covers the cutter tube blade to protect the organ.
1. Visual check
• Check the product for sealing, corrosion and sterility.
• Ensure that it is free from rust, dents and scratches.
• The distal end of the Obturator must not be damaged.
• The sealing flap and the seal must not be damaged.
Risk of injury
Select blade. Make sure that the cutting edge of the blade is sharp and undamaged (e.g. no cracks or
burrs).
2. Insert the cutting tube through the gear unit
Remove the seal unit from the gear unit.
Insert the cutting tube through the gear unit. The two guide
pins on the cutting tube must fit into the slot on the flange of
the gear unit.
3. Fixing the cutting tube to the gear unit
Hold the cutting tube with one hand.
With the other hand screw the seal unit onto the gear unit.
4. Mounting Trocar Cannula
Select a suitable Trocar Cannula. Open the Trocar Can-
nula valve by actuating the lever to prevent damage to
the cutting tube by pushing the Trocar too far.
Push the Trocar Cannula over the distal end of the cutting
tube. The guide pin of the Trocar Cannula must be in the dis-
tal slot of the gear unit.
Lock the Trocar Cannula in position with a click.
Instrucions for use for TCM 3000 BL - Morcellator, Ref. 31946, V26/16
EN
15