Operation; Switching The Device On And Off; Regulation Of The Infiltration Process; Flexible Tube Pump - Nouvag DP30 Mode D'emploi

7

Operation

7.1

Switching the device on and off

Use the power switch "I/O" at the rear of the control unit to switch the control unit on and off.
The device may be switched off at any time irrespective of any procedure for switching off the device.
The green indicator light up left on the operation panel is on, when the main switch is switched on and the
device is ready for operation.
7.2

Regulation of the infiltration process

With ON/OFF pedal
Control dial in conjunction with ON/OFF pedal
The desired volumetric displacement is set with the control dial. The pumping process is started by
actuating the ON/OFF pedal. The volumetric displacement can be varied at any time using the control dial.
Control dial in conjunction with VARIO pedal
The maximum volumetric displacement can be varied at any time using the control dial, even while the
pedal is being pressed. Control using the VARIO pedal regulates the volumetric displacement of the pump
up to the set maximum value.
7.3

Flexible tube pump

Turn control dial clockwise from the OFF position. Pump starts, liquid emerges from the open tube end.
Turning the dial up to the maximum value controls the increase in volumetric displacement.
The pump stops immediately when the release button of the pump compartment is pressed.
7.4

Functional check

Prior to Dispenser DP 30 startup or use of accessory equipment, the user must always ensure that each
individual component is in good working order, free of defects, clean, sterile and operational. The tube set
has to correspond with the correct flow direction (6.2 Device Preparation) and the pump has to function.
The green LED is on after the device is switched on.
10
With VARIO pedal
Dispenser DP 30, operating instructions, REF 31678, V52/17
Dispenser DP 30