Startup; Connection To The Power Supply; Device Preparation - Nouvag DP30 Mode D'emploi

6

Startup

6.1

Connection to the power supply

In order to prevent the risk of electric shock, the device may only be connected to a power network with
a PE protective earth conductor.
If the voltage shown does not correspond to the local mains voltage, the grey fuse holder must be set to the
correct voltage:
A) Switch off device.
B) Unplug the power cable.
C) Use a screwdriver to open the fuse slot.
D) Remove the fuse holder.
E) Remove the grey fuse holder and reinsert it so that the local mains voltage setting is shown in the
small window.
F) Slide the grey fuse holder back in and close the fuse slot.
G) Check the mains voltage shown on the fuse slot.
H) Plug the power cable back into the device.
6.2

Device preparation

1. Insert the stand for the irrigation fluid into the stand holder.
2. Plug the pedal plug into the pedal socket at the rear of the control unit.
3. Assemble the tubing set (see images).
Check the expiry date of the tubing set and ensure that the packaging is not damaged. Using
non-sterile tubing sets can result in serious infection, and in extreme cases, can be fatal.
When inserting the tubing set, notice the arrow marked on the tubing set bracket. It indicates
the direction of flow of the infiltration liquid.
Do not regulate the amount of irrigation fluid using the roller clamp on the tube set; with the Dispenser
DP 30, this is regulated instead using the control dial and the foot pedal. For this reason, make sure to
open the roller clamp as far as it will go.
Use only the Nouvag tube set, otherwise the function cannot be guaranteed.
The container of irrigation fluid may weigh a maximum of 2 kg. Heavier containers than allowed can cause
the device to tip over.
8 Dispenser DP 30, operating instructions, REF 31678, V52/17
Dispenser DP 30