Malfunctions And Troubleshooting; Spare Parts List With Order Numbers; Dispenser Dp 30, Operating Instructions, Ref 31678, V52 - Nouvag DP30 Mode D'emploi

Dispenser DP 30
10

Malfunctions and troubleshooting

Malfunction
Device is not functional
(Indicator light is not on)
Pump doesn't work
(Indicator light is on)
Pedal doesn't work
(Indicator light is on)
If the problem cannot be solved please contact your supplier or an authorized service center. The addresses are provided in
the appendix of this operation manual under "Service center".
11

Spare parts list with order numbers

Accessories
ON/OFF pedal, IPX8 --------------------------------------------------------------------------------------------------------------- 1513
VARIO pedal, IPX8 ---------------------------------------------------------------------------------------------------------------- 1501
Stand for irrigation fluid bottle ------------------------------------------------------------------------------------------------ 1770
Tubing set with spike, roller clamp and Luer Lock, sterile, 4 m, single-use --------------------------------------- 6022
Operation manual for Dispenser DP 30 on CD-ROM ----------------------------------------------------------------- 31678*
*A printed version of the operation manual is available at Nouvag AG, free of charge. At order please designate
that you wish to receive a printed version.
To order additional parts, please contact our customer service department.

Dispenser DP 30, operating instructions, REF 31678, V52/17

Cause
Control unit not switched on Set the power switch "I/O"
Power connection not
established
Incorrect operating voltage
Faulty fuse
Control switch is on too low
position or "Off"
Tubing set incorrectly
inserted
Incorrect operation
Pedal was not pressed
Roller clamp is closed
Pedal is not connected
Incorrect operation
Solution
to "I"
Connect the control unit to
the mains power supply
Check the mains voltage
Replace the fuse
Raise pump performance by
turning control switch up
Insert tubing set correctly
(note the direction)
Check operating instructions 6.2 Device preparation
Press pedal
Open Roller clamp all the way 6.2 Device preparation
Connect pedal with the
socket on rear of device
Check operating instructions 7.2 Regulation of infiltration
Refer to the operating
instructions
7.1 Switching the device on and off
6.1. Connection to the power
supply
6.1. Connection to the power
supply
9.1 Replacing the control unit fuse
7.2 Regulation of infiltration
process
6.2 Device preparation
7.2 Regulation of infiltration
process
5.0 Device overview
6.2 Device preparation
process
6.2 Device preparation
EN
REF
13