Malfunction And Troubleshooting - Nouvag TCM 3000bl Mode D'emploi

TCM 3000 BL - Morcellator
8.4

Malfunction and troubleshooting

Malfunction
Device is not Control unit not switched on Set the power switch
operational
(display is not on)
Power connection not estab-
lished
Incorrect operating voltage
Faulty fuse
Motor does not run Motor not switched on
Motor not connected
Gear unit not correctly in-
stalled
Foot switch does not Foot switch not connected
operate
(display is on)
If a fault cannot be rectified, please contact your supplier or an authorized service centre.
The addresses are provided on the last page of the operating instructions.
Instrucions for use for TCM 3000 BL - Morcellator, Ref. 31946, V26/16
Cause
"I/O" to "I"
connect
Check the mains voltage
Replace the fuse
Switch on the motor using the
treadplate
Connect the motor cable to the
control unit
Press the electric motor firmly
onto the gear unit coupling until
it clicks into position and check
that it is secure by moving it
slightly in the opposite direction.
Plug foot switch cable into the
foot switch socket.
Refer to the operating
Solution
5.2.1 Assembly of the Morcellator set
with protective tube (option 1)
5.2.2 Assembly of the Morcellator set
with Trocar Cannula (option 2)
5.2.1 Assembly of the Morcellator set
with protective tube (option 1)
5.2.2 Assembly of the Morcellator set
with Trocar Cannula (option 2)
5.1. Connection to the power supply
8.2 Replacing the control unit fuse
6.1 Using the control unit
5.2.1 Assembly of the Morcellator set
with protective tube (option 1)
5.2.2 Assembly of the Morcellator set
with Trocar Cannula (option 2)
5.2.1 Assembly of the Morcellator set
with protective tube (option 1)
5.2.2 Assembly of the Morcellator set
with Trocar Cannula (option 2)
5.2.1 Assembly of the Morcellator set
with protective tube (option 1)
5.2.2 Assembly of the Morcellator set
with Trocar Cannula (option 2)
instructions
EN
39