Dip-Switches - DITEC GLOBE IP1839 Manuel D'installation Et D'entretien

5.2 Dip-Switches

Description
DIP1 Control 1-5 function.
DIP2 Selection of direction.
DIP3 Disengagement on the closing
stop with JR2=ON
Disengagement on the closing
stop with JR2=OFF
DIP4 State of door at start.
Indicates how the electronic panel
considers the door at the time of
start.
DIP5 Electric lock release.
DIP6 Pre-flashing light.
5.3 Jumpers
Description
SO Safety operation.
JR2 Automation type.
JR3 Maximum limit manoeuvering
forces.
JR4 Built-in radio receiver.
5.4 Signals
LED
POWER ALARM
SA
SIG
Step by step.
Opening towards gearmotor.
2 mm
Open.
With DIP1=OFF the first control 1-5 closes
the door.
With DIP1=ON the first control 1-5 opens
the door.
Disabled.
Disabled during opening.
Enabled only with automatic closure with
TC>3 s.
The opening of contact 1-8 with door
stopped enables opening manoeuvre. In
the last 30 mm before closing stop, this
causes stop.
Up and over door with counterweight.
Normal closing force.
Note: use safety edge.
Disabled.
ON
24 V= power supply.
Indicates that at least one of the N.C. safety con-
tacts is open.
During radio transmitter enabling/storing phase.
OFF
Opening.
Closing towards gearmotor.
0,5 mm
Note: use this selection to prevent an in-
complete closing of the sectional doors.
5 mm
Close.
The first control 1-5 opens the door.
Note: automatic closing cannot be the first
control even if enabled.
Enabled.
Before opening from closed door, a thrust
is included in closing to facilitate electric
lock release.
Enabled for both opening and closing.
OFF
The opening of contact 1-8 with door
stopped prevents any operation.
Sectional and up and over door with springs.
Reduced closing force.
Enabled.
Encoder / automation fault.
Upon starting the LED flashes indicating the count
of the operations which have been carried out:
each quick flashing = 1000 operations
each slow flashing = 10000 operations
During radio transmission reception.
21
ON
ON
Flashing
GLOBE - IP1839
GB